American Made
206 Nance Rd. NE. Calhoun, Ga. 30701
Phone: (888) 685-0025 Fax: (888) 781-5255
CASA ADHESIVE, INC.
CASA 465 QUICK-HIDE
Application Procedures
>
Ambient conditions should be 60 degrees F or above for coatings to perform per data sheet information.
Ambient conditions should be 60 degrees F or above for coatings to perform per data sheet information. >Materials to be bonded should be clean, dry and dust free. Any petroleum based products such as oil or grease can prevent suitable bonding.
Materials to be bonded should be clean, dry and dust free. Any petroleum based products such as oil or grease can prevent suitable bonding.>Quick-Hide can be brushed, rolled or sprayed. Different textures are accomplished using varying application techniques. When spraying, textured finishes are best achieved using a spatter gun. Spray guns should be adjusted to give a paint-like spray pattern. Hold the spray gun 8-12 inches from the surface with each pass to ensure uniform coverage.
Quick-Hide can be brushed, rolled or sprayed. Different textures are accomplished using varying application techniques. When spraying, textured finishes are best achieved using a spatter gun. Spray guns should be adjusted to give a paint-like spray pattern. Hold the spray gun 8-12 inches from the surface with each pass to ensure uniform coverage.>Allow this coating to thoroughly dry and harden. Under normal ambient room temperatures, this will take less than 1 hour. The coating will be dry to the touch in 30 minutes. Using a fan blowing over the coated surface may accelerate drying time.
Allow this coating to thoroughly dry and harden. Under normal ambient room temperatures, this will take less than 1 hour. The coating will be dry to the touch in 30 minutes. Using a fan blowing over the coated surface may accelerate drying time. >The final cure is achieved once the residual water has evaporated. Although water evaporation happens quickly, it is recommended users wait 24 hours before performing any final testing.
The final cure is achieved once the residual water has evaporated. Although water evaporation happens quickly, it is recommended users wait 24 hours before performing any final testing.>New associates assigned to industrial coatings positions should be trained in all required procedures.
New associates assigned to industrial coatings positions should be trained in all required procedures. >Casa’s water-based coatings must be used in conjunction with stainless steel or plastic parts where the coatings comes in contact with hose fittings, spray guns, diaphragm pumps or pressure pots.
Casa’s water-based coatings must be used in conjunction with stainless steel or plastic parts where the coatings comes in contact with hose fittings, spray guns, diaphragm pumps or pressure pots.>Casa’s 465 water-based, non-toxic coatings eliminate associate health issues, flash fire issues and eliminate environmental VOC emissions.
Casa’s 465 water-based, non-toxic coatings eliminate associate health issues, flash fire issues and eliminate environmental VOC emissions. Procedures
465
CASA Adhesive, Inc.
For A Cleaner Environment
